DPA 2011ER Twin Diaphragm Cardioid Mic, Rear Cable, XLR
;)
;)
;)
Please contact us on +45 3120 7021 or info@nordicproaudio.com
DPA 2011ER Twin Diaphragm Cardioid Mic
At any time, and with no tools needed, it is possible to transform the 2011 Twin Diaphragm Cardioid Mic into a new configuration with the MMP-ER Preamp with Rear Cable . The 2011 is very widely used as a snare drum mic but fits easily well on many other instruments.
Distinctive, well-balanced sound
The 2011 Twin Diaphragm Cardioid Mic is a directional microphone. The distinctive sound of this microphone is well balanced. It bridges the gap between the extreme sound quality of our pencil microphones and our well-known Lavalier microphones.
- Blends clarity, richness and dynamics
- Twin Diaphragm Capsule Technology
- Advanced Interference Tube Technology
- Superb stage separation and level control
- Modular flexibility
Two opposite-facing miniature capsules are custom rebuilt inside this microphone. They are placed into a double-diaphragm, one-capsule composition. This combines the advantages of small capsules with the lower inherent noise achieved from a larger diaphragm area. These capsules provide fast impulse response and large frequency bandwidth. The capsules are loaded to our supreme preamps, which gives the sound more air and precision.
Combine it with the preamp of your choice
As with all of our modular pencil microphones, you can combine the 2011 Twin Diaphragm Cardioid Mic Capsule with any of our preamps.
The MMP-A Mic Preamp is an ultra-transparent, transformerless preamplifier with active drive for impedance balancing. The MMP-C Compact Mic Preamp is an ultra-compact preamplifier with active drive for impedance balancing. It has a slightly softer character than the other preamps for our pencil microphones. Other preamps include the very small form factor types MMP-E Modular Active Cable (XLR output) and MMP-G Modular Active Cable (MicroDot output), allowing for very slim set-ups. The MMP-G even allows you to match a larger microphone directly to a wireless transmitter.
- 1x DPA 2011ER Twin Diaphragm Cardioid Mic, Rear Cable, XLR
- 1x Foam Windscreen
- 1x Clip
- 1x Clip for MMP-E
| Directional Pattern: | Cardioid |
|---|---|
| Principle of operation: | Pressure gradient, with interference tube |
| Cartridge type: | Pre-polarized condenser, Twin Diaphragm Capsule |
| Frequency response: | 20 Hz - 20 kHz |
| Preamp: | MMP-ER - Preamp with Rear Cable |
| Effective frequency range, ±2 dB, at 30 cm (11.8 in): | 50 Hz - 17 kHz with 3 dB soft boost at 12 kHz |
| Sensitivity, nominal, ±2 dB at 1 kHz: | 10 mV/Pa; -40 dB re. 1 V/Pa |
| Equivalent noise level, A-weighted: | Typ. 20 dB(A) re. 20 µPa (max. 23 dB(A)) |
| Equivalent noise level, ITU-R BS.468-4: | Typ. 33 dB (max. 36 dB) |
| Minimum load impedance: | 2 kΩ |
| Rated output impedance: | 100 Ω |
| Cable drive capability: | 100 m (328 ft) |
| Output balance principle: | Impedance balancing |
| Common mode rejection ratio (CMRR): | > 40 dB |
| Power supply (for full performance): | P48 (Phantom Power) |
| Current consumption: | 3.5 mA |
| Maximum output voltage, RMS: | 2.2 V |
| Polarity: | +V at pin 2 for positive sound pressure |
| Sensitivity selection tolerance (at 1 kHz): | ±1.5 dB |
| Weight: | 24 g (0.8 oz) |
| Microphone diameter: | 19 mm (0.75 in) |
| Microphone length: | 51 mm (2.0 in) |
| Temperature range: | -40°C to 45°C (-40°F to 113°F) |
| Relative humidity (RH): | Up to 90% |