DPA 4006 Omni Mic Capsule
Please contact us on +45 3120 7021 or info@nordicproaudio.com
The MMC4006 Omnidirectional Microphone Capsule is a linear omnidirectional mic capsule. There is no other mic in the world as lauded as it is.
This microphone offers total transparency in any recording situation. It picks up incredible detail and depth of sound. The definition of its high-frequency characteristics across a wide range of instruments is impressive. It offers natural sound, high sensitivity, low noise-floor and extremely linear frequency response from 10 to 20 kHz (±2 dB)
The MMC4006 Capsule is part of the flexible Pencil Microphone series. The MMC4006A, with the MMP-A preamplifier, is the audiophile’s choice. It provides low distortion and accurate sound. The MMC4006C, with the MMP-C compact preamplifier, offers a subtle character alteration with a bit more 'body' to the low end. The MMC4006C is also easier to position due to its small size.
- 1x DPA 4006 Omni Mic Capsule
| Directional Pattern: | Omnidirectional |
|---|---|
| Principle of operation: | Pressure gradient |
| Cartridge type: | Pre-polarized condenser |
| Frequency response: | 10 Hz - 20 kHz |
| Dynamic range: | Typ. 124 dB |
| Effective frequency range ±2 dB: | 10 Hz - 20 kHz |
| Sensitivity, nominal, ±2 dB at 250 Hz: | 40 mV/Pa; -28 dB re. 1 V/Pa |
| Equivalent noise level, A-weighted: | Typ. 15 dB(A) re. 20 µPa (max. 17 dB(A)) |
| Equivalent noise level, ITU-R BS.468-4: | Typ. 27 dB (max. 29 dB) |
| Distortion, THD < 1%: | 136 dB SPL RMS, 139 dB SPL peak |
| Max. SPL, THD 10%: | 146 dB SPL peak |
| Switchable attenuator, filters etc.: | 0 dB / -20 dB |
| Minimum load impedance: | 2 kΩ |
| Rated output impedance: | 200 Ω |
| Cable drive capability: | 100 m (328 ft) |
| Output balance principle: | Impedance balancing with Active Drive |
| Common mode rejection ratio (CMRR): | > 60 dB |
| Power supply (for full performance): | P48 (Phantom Power) |
| Current consumption: | 2.8 mA |
| Maximum output voltage, RMS: | 8.0 V |
| Polarity: | +V at pin 2 for positive sound pressure |
| Matching tolerance (frequency response and sensitivity): | ±0.5 dB |
| Phase deviation for kit: | < 5° |
| Microphone diameter: | 16 - 19 mm (0.6 - 0.75 in) |
| Capsule diameter: | 16 mm (0.6 in) |
| Microphone length: | 170 mm (6.7 in) |
| Temperature range: | -40°C to 45°C (-40°F to 113°F) |
| Relative humidity (RH): | Up to 90% |
Related products
