DPA 4017 Shotgun Microphone Capsule
Please contact us on +45 3120 7021 or info@nordicproaudio.com
This condenser microphone capsule is part of our selection of pencil microphones. It is equipped with a highly-directional hypercardioid pickup pattern; obtained using a supercardioid design with an interference tube that provides excellent off-axis rejection. The MMC4017 Shotgun Microphone Capsule is fully immune to RF emission and the 19 mm (0.75 in) condenser cartridge is capable of handling peak SPLs of 152 dB before clipping.
Designed for a broad range of applications, the Pencil Microphones Series is ideal for use with camera systems, in fixed positions at sports facilities, for broadcast/ENG / film booming and even studio recording environments.
The capsule, combined with the MMP-B preamplifier, is a short and exceptionally lightweight shotgun microphone with impressive accuracy, clarity and musicality.
- 1x DPA 4017 Shotgun Microphone Capsule
| Directional Pattern: | Supercardioid, lobe-shaped |
|---|---|
| Principle of operation: | Pressure gradient, with interference tube |
| Cartridge type: | Pre-polarized condenser |
| Frequency response: | 20 Hz - 20 kHz, permanent third order high pass filter at 50 Hz |
| Dynamic range: | Typ. 124 dB |
| Effective frequency range, ±2 dB, at 60 cm (23.6 in): | 70 Hz - 18 kHz with typ. 3 dB soft boost at 15 kHz |
| Sensitivity, nominal, ±2 dB at 1 kHz: | 19 mV/Pa; -34.4 dB re. 1 V/Pa |
| Equivalent noise level, A-weighted: | Typ. 13 dB(A) re. 20 µPa (max. 15 dB(A)) |
| Equivalent noise level, ITU-R BS.468-4: | Typ. 24 dB (max. 26 dB) |
| Distortion, THD < 1%: | 134 dB SPL RMS, 137 dB SPL peak |
| Max. SPL, THD 10%: | 138 dB SPL peak |
| Switchable attenuator, filters etc.: | High boost: +4 dB at 8 kHz. Low cut: First order filter, below 120 Hz |
| Minimum load impedance: | 2 kΩ |
| Rated output impedance: | 100 Ω |
| Cable drive capability: | 100 m (328 ft) |
| Output balance principle: | Signal balanced |
| Common mode rejection ratio (CMRR): | > 40 dB |
| Power supply (for full performance): | P48 (Phantom Power) |
| Current consumption: | 4.5 mA |
| Maximum output voltage, RMS: | 2.0 V |
| Polarity: | +V at pin 2 for positive sound pressure |
| Microphone diameter: | 19 mm (0.75 in) |
| Capsule diameter: | 19 mm (0.75 in) |
| Microphone length: | 212 mm (8.3 in) |
| Temperature range: | -40°C to 45°C (-40°F to 113°F) |
| Relative humidity (RH): | Up to 90% |