Microphones » Shotgun »
DPA 4017B-R Shotgun Mic with Rycote Windshield
;)
;)
;)
DKK 13.225,00
All amounts are ex. VAT
Ordering number:
4017B-RGTIN number:
5713055001148
Got any questions or in the need of advice?
Please contact us on +45 3120 7021 or info@nordicproaudio.com
Please contact us on +45 3120 7021 or info@nordicproaudio.com
Windshield kit for every weather condition
DPA Microphones has joined forces with Rycote® to develop a Windshield Kit Solution for the 4017B Shotgun Microphone. The strong suspension and windshield solution has been designed specifically to take the mic’s small size and light weight into consideration. Special soft lyres are selected to optimize vibration isolation.
Using this kit together with the 4017B Shotgun Microphone provides everything an outside broadcaster, journalist or location film maker needs for clear, directional sound, regardless of the weather and environmental conditions.
DPA 4017B Frequency Response:
DPA 4017B Frequency Response with Filters:
DPA 4017B Polar Pattern:
- 1x 4017B Shotgun Microphone
- 1x Rycote Windshield Kit
- 1x Foam Windscreen
- 1x Clip
| Directional Pattern: | Supercardioid, lobe-shaped |
|---|---|
| Principle of operation: | Pressure gradient, with interference tube |
| Cartridge type: | Pre-polarized condenser |
| Frequency response: | 20 Hz - 20 kHz, permanent third order high pass filter at 50 Hz |
| Dynamic range: | Typ. 124 dB |
| Effective frequency range, ±2 dB, at 60 cm (23.6 in): | 70 Hz - 18 kHz with typ. 3 dB soft boost at 15 kHz |
| Sensitivity, nominal, ±2 dB at 1 kHz: | 19 mV/Pa; -34.4 dB re. 1 V/Pa |
| Equivalent noise level, A-weighted: | Typ. 13 dB(A) re. 20 µPa (max. 15 dB(A)) |
| Equivalent noise level, ITU-R BS.468-4: | Typ. 24 dB (max. 26 dB) |
| Distortion, THD < 1%: | 134 dB SPL RMS, 137 dB SPL peak |
| Max. SPL, THD 10%: | 138 dB SPL peak |
| Switchable attenuator, filters etc.: | High boost: +4 dB at 8 kHz. Low cut: First order filter, below 120 Hz |
| Minimum load impedance: | 2 kΩ |
| Rated output impedance: | 100 Ω |
| Cable drive capability: | 100 m (328 ft) |
| Output balance principle: | Signal balanced |
| Common mode rejection ratio (CMRR): | > 40 dB |
| Power supply (for full performance): | P48 (Phantom Power) |
| Current consumption: | 4.5 mA |
| Maximum output voltage, RMS: | 2.0 V |
| Polarity: | +V at pin 2 for positive sound pressure |
| Weight: | 68 g (2.4 oz) |
| Microphone diameter: | 19 mm (0.75 in) |
| Capsule diameter: | 19 mm (0.75 in) |
| Microphone length: | 212 mm (8.3 in) |
| Temperature range: | -40°C to 45°C (-40°F to 113°F) |
| Relative humidity (RH): | Up to 90% |