DPA 2011A Stereo Pair with Clips and Windscreens in Peli Case
DKK 14.200,00
All amounts are ex. VAT
Ordering number:
ST2011AGTIN number:
5713055002015
Got any questions or in the need of advice?
Please contact us on +45 3120 7021 or info@nordicproaudio.com
Please contact us on +45 3120 7021 or info@nordicproaudio.com
DPA 2011A Stereo Pair
These mics are acclaimed for their close-miking excellence and high-SPL handling. Optimized for onstage use, it has been used on many stages as well as recording sessions. They exhibit a previously unheard blend of clarity, richness and dynamic range. The off-axis response is linear but in a smaller frequency bandwidth. This makes stage separation and gain-to-feedback higher. The mic level is easier to control.
- Modularity – interchangable capsules and preamplifiers
- Up to 120 dB dynamic range
- RF rejection between >60 and >40 dB
- Linear frequency response
- High SPL
- Superior gain before feedback
The foam design in the heavy-duty transportation box allows for fast and easy exchange of the microphone/accessory inlays.
- 2x DPA 2011A Twin Diaphragm Cardioid Microphones
- 2x DPA Microphone Clips
- 2x Foam Windscreens
- 1x Peli Case
| Directional Pattern: | Cardioid |
|---|---|
| Principle of operation: | Pressure gradient, with interference tube |
| Cartridge type: | Pre-polarized condenser, Twin Diaphragm Capsule |
| Frequency response: | 20 Hz - 20 kHz |
| Dynamic range: | Typ. 117 dB |
| Effective frequency range, ±2 dB, at 30 cm (11.8 in): | 50 Hz - 17 kHz with 3 dB soft boost at 12 kHz |
| Sensitivity, nominal, ±2 dB at 1 kHz: | 10 mV/Pa; -40 dB re. 1 V/Pa |
| Equivalent noise level, A-weighted: | Typ. 20 dB(A) re. 20 µPa (max. 23 dB(A)) |
| Equivalent noise level, ITU-R BS.468-4: | Typ. 33 dB (max. 36 dB) |
| Distortion, THD < 1%: | 134 dB SPL RMS, 137 dB SPL peak |
| Max. SPL, THD 10%: | 153 dB SPL peak |
| Switchable attenuator, filters etc.: | 0 dB / -20 dB |
| Rated output impedance: | 200 Ω |
| Minimum load impedance: | 2 kΩ |
| Cable drive capability: | 100 m (328 ft) |
| Output balance principle: | Impedance balancing with Active Drive |
| Common mode rejection ratio (CMRR): | > 60 dB |
| Power supply (for full performance): | P48 (Phantom Power) |
| Current consumption: | 2.8 mA |
| Maximum output voltage, RMS: | > 5 V |
| Polarity: | +V at pin 2 for positive sound pressure |
| Sensitivity selection tolerance (at 1 kHz): | ±1.5 dB |
| Microphone diameter: | 19 mm (0.75 in) |
| Microphone length: | 198 mm (7.8 in) |
| Temperature range: | -40°C to 45°C (-40°F to 113°F) |
| Relative humidity (RH): | Up to 90% |