DPA 4006C Stereo Pair with Clips and Windscreens in Peli Case
DKK 30.440,00
All amounts are ex. VAT
Ordering number:
ST4006CGTIN number:
5713055000240
Got any questions or in the need of advice?
Please contact us on +45 3120 7021 or info@nordicproaudio.com
Please contact us on +45 3120 7021 or info@nordicproaudio.com
DPA 4006C Stereo Pair
This kit is similar to the ST4006A Stereo Pair, using the same MMC4006 Omnidirectional Microphone Capsule to gain its amazing sound. Whenever a small, lightweight, inconspicuous microphone for top-quality recording is required, a 4006C Omnidirectional Microphone is the right choice. They come as a hand-matched pair that offers the truest capture of stereo sound available.
- Modularity – interchangable capsules and preamplifiers
- Up to 120 dB dynamic range
- RF rejection between >60 and >40 dB
- Linear frequency response
- High SPL
- Superior gain before feedback
- 2x DPA 4006C Compact Omni Microphones
- 2x Free-Field Grids
- 2x Close-Miking Grids
- 2x Diffuse-Field Grid
- 2x DPA Microphone Clips
- 2x DPA Foam Windscreens
- 1x Peli Case
| Directional Pattern: | Omnidirectional |
|---|---|
| Principle of operation: | Pressure gradient |
| Cartridge type: | Pre-polarized condenser |
| Frequency response: | 10 Hz - 20 kHz |
| Dynamic range: | Typ. 119 dB |
| Effective frequency range ±2 dB: | 20 Hz - 20 kHz |
| Sensitivity, nominal, ±2 dB at 250 Hz: | 40 mV/Pa; -28 dB re. 1 V/Pa |
| Equivalent noise level, A-weighted: | Typ. 15 dB(A) re. 20 µPa (max. 17 dB(A)) |
| Equivalent noise level, ITU-R BS.468-4: | Typ. 27 dB (max. 29 dB) |
| Distortion, THD < 1%: | 131 dB SPL RMS, 134 dB SPL peak |
| Max. SPL, THD 10%: | 139 dB SPL peak |
| Rated output impedance: | 100 Ω |
| Minimum load impedance: | 2 kΩ |
| Cable drive capability: | 100 m (328 ft) |
| Output balance principle: | Impedance balancing with Active Drive |
| Common mode rejection ratio (CMRR): | > 50 dB |
| Power supply (for full performance): | P48 (Phantom Power) |
| Current consumption: | 2.8 mA |
| Maximum output voltage, RMS: | 4.5 V |
| Polarity: | +V at pin 2 for positive sound pressure |
| Matching tolerance (frequency response and sensitivity): | ±0.5 dB |
| Phase deviation for kit: | < 5° |
| Microphone diameter: | 16 - 19 mm (0.6 - 0.75 in) |
| Capsule diameter: | 16 mm (0.6 in) |
| Microphone length: | 64 mm (2.5 in) |
| Temperature range: | -40°C to 45°C (-40°F to 113°F) |
| Relative humidity (RH): | Up to 90% |