DPA 4015C Stereo Pair with Clips and Windscreens in Peli Case
Please contact us on +45 3120 7021 or info@nordicproaudio.com
DPA 4015C Stereo Pair
A complete Stereo Pair with two carefully factory-matched 4015C Wide Cardioid Microphones. Even though the standard tolerances on our recording mic series is extremely low, a stereo match is even closer. These mics are matched within ±1 dB on both frequency response and sensitivity. The pair comes with two 4015 mics, clips and windscreens in a Peli™ Case.
This pair is similar to the ST4015A Stereo Pair, using the same MMC4015 Wide Cardioid Microphone Capsule to gain its amazing sound.
Visually discreet, the 4015C Compact Wide Cardioid Microphone represents an indispensably low-profile solution for audio engineers and set designers alike. Tremendously precise and natural sounding, these mics will certainly exceed expectations when used on choirs, percussion setups, grand pianos, wind instruments and much more.
The foam design in the heavy-duty transportation box allows for fast and easy exchange of the microphone/accessory inlays
Whats Included:
- 2x DPA 4015C Compact Wide Cardioid Mic
- 2x DPA Microphone Clips
- 2x Foam Windscreens
- 1x Peli Case
| Directional Pattern: | Wide cardioid |
|---|---|
| Principle of operation: | Pressure gradient |
| Cartridge type: | Pre-polarized condenser |
| Frequency response: | 20 Hz - 20 kHz |
| Dynamic range: | Typ. 121 dB |
| Effective frequency range, ±2 dB, at 60 cm (23.6 in): | 40 Hz - 20 kHz |
| Sensitivity, nominal, ±2 dB at 1 kHz: | 10 mV/Pa; -40 dB re. 1 V/Pa |
| Equivalent noise level, A-weighted: | Typ. 18 dB(A) re. 20 µPa (max. 20 dB(A)) |
| Equivalent noise level, ITU-R BS.468-4: | Typ. 25 dB |
| Distortion, THD < 1%: | 136 dB SPL RMS, 139 dB SPL peak |
| Max. SPL, THD 10%: | 152 dB SPL peak |
| Minimum load impedance: | 2 kΩ |
| Rated output impedance: | 100 Ω |
| Cable drive capability: | 100 m (328 ft) |
| Output balance principle: | Impedance balancing with Active Drive |
| Common mode rejection ratio (CMRR): | > 50 dB |
| Power supply (for full performance): | P48 (Phantom Power) |
| Current consumption: | 2.8 mA |
| Maximum output voltage, RMS: | > 4 V |
| Polarity: | +V at pin 2 for positive sound pressure |
| Matching tolerance (frequency response and sensitivity): | ±1 dB |
| Phase deviation for kit: | < 10° |
| Microphone diameter: | 19 mm (0.75 in) |
| Capsule diameter: | 19 mm (0.75 in) |
| Microphone length: | 64 mm (2.5 in) |
| Temperature range: | -40°C to 45°C (-40°F to 113°F) |
| Relative humidity (RH): | Up to 90% |