DPA 2006A Twin Diaphragm Omni Mic
Please contact us on +45 3120 7021 or info@nordicproaudio.com
For the true audiophile
The 2006A Twin Diaphragm Omni Mic offers low distortion and totally accurate and faithful sound
Distinctive, well-balanced sound
Our unique Twin Diaphragm Omni Mic Capsule is at the heart of these amazing microphones. This capsule gives the mic a distinctive, well-balanced sound and bridges the gap between the extreme sound quality of our pencil microphones and our well-known lavalier microphones.
- Acoustic authenticity
- Linear throughout a large frequency bandwidth
- Twin-Diaphragm Capsule Technology
- Modular flexibility
Two opposite-facing miniature capsules are custom rebuilt inside this microphone. They are placed into a double-diaphragm, one-capsule composition. This combines the advantages of small capsules with the lower inherent noise achieved from a larger diaphragm area. These capsules provide fast impulse response and large frequency bandwidth. The capsules are loaded to our supreme preamps, which gives the sound more air and precision.
Combine it with the preamp of your choice
As with all of our modular pencil microphones, you can combine the Twin Diaphragm Omni Mic Capsule with any of our preamps.
The MMP-A Mic Preamp is an ultra-transparent, transformerless preamp with active drive for impedance balancing. The MMP-C Compact Mic Preamp is an ultra-compact preamp with active drive for impedance balancing. It has a slightly softer character than the other preamps for our pencil microphones.
Other preamps include the very small form factor types MMP-E Modular Active Cable (XLR output) and MMP-G Modular Active Cable (MicroDot output), allowing for very slim set-ups. The MMP-G even allows you to match a larger microphone directly to a wireless transmitter..
At any time, and with no tools needed, it is possible to transform the 2006 Twin Diaphragm Omni Mic into a new configuration
- 1x DPA 2006A Twin Diaphragm Omni Mic
- 1x Clip
- 1x Foam Windscreen
Directional Pattern: | Omnidirectional |
---|---|
Principle of operation: | Pressure gradient |
Cartridge type: | Pre-polarized condenser, Twin Diaphragm Capsule |
Frequency response: | 20 Hz - 20 kHz |
Dynamic range: | Typ. 114 dB |
Preamp: | MMP-A - Standard Preamp |
Effective frequency range ±2 dB: | 50 Hz - 20 kHz with typ. 3 dB soft boost at 14 kHz |
Sensitivity, nominal, ±2 dB at 1 kHz: | 40 mV/Pa; -28 dB re. 1 V/Pa |
Equivalent noise level, A-weighted: | Typ. 16 dB(A) re. 20 µPa (max. 18 dB(A)) |
Equivalent noise level, ITU-R BS.468-4: | Typ. 28 dB (max. 30 dB) |
Distortion, THD < 1%: | 127 dB SPL RMS, 130 dB SPL peak |
Max. SPL, THD 10%: | 146 dB SPL peak |
Switchable attenuator, filters etc.: | 0 dB / -20 dB |
Minimum load impedance: | 2 kΩ |
Rated output impedance: | 200 Ω |
Cable drive capability: | 100 m (328 ft) |
Output balance principle: | Impedance balancing with Active Drive |
Common mode rejection ratio (CMRR): | > 60 dB |
Power supply (for full performance): | P48 (Phantom Power) |
Current consumption: | 2.8 mA |
Maximum output voltage, RMS: | 8 V |
Polarity: | +V at pin 2 for positive sound pressure |
Sensitivity selection tolerance (at 1 kHz): | ±1.5 dB |
Weight: | 160 g (5.6 oz) |
Microphone diameter: | 19 mm (0.75 in) |
Microphone length: | 164 mm (6.5 in) |
Temperature range: | -40°C to 45°C (-40°F to 113°F) |
Relative humidity (RH): | Up to 90% |