DPA 2006A Stereo Pair with Clips and Windscreens in Peli Case
DPA 2006A Stereo Pair
Together with the MMP-A preamp this condenser mic bridges the gap between the extreme sound quality of our recording mic series and our well-known miniature mic series.
- Modularity – interchangable capsules and preamplifiers
- Up to 120 dB dynamic range
- RF rejection between >60 and >40 dB
- Linear frequency response
- High SPL
- Superior gain before feedback
Inside the MMC2006 Twin Diaphragm Omnidirectional Capsule, two opposite-facing miniature capsules are custom rebuilt. They are placed into a double-diaphragm, one-capsule composition. This combines the advantages of small capsules with the lower inherent noise achieved from a larger diaphragm area. These capsules provide fast impulse response and large frequency bandwidth.
Comparisons with its big brother, the iconic DPA 4006 Omnidirectional Microphone, are inevitable. The relationship between the two can be clearly heard. The 2000 series performs as well as more exclusive microphones. It is a premium-class microphone and redefines the term value for money.
- 2x DPA 2006A Twin Diaphragm Omni Miccrophones
- 2x Foam Windscreens
- 2x DPA Microphone Clips
- 1x Peli Case
| Directional Pattern: | Omnidirectional |
|---|---|
| Principle of operation: | Pressure gradient |
| Cartridge type: | Pre-polarized condenser, Twin Diaphragm Capsule |
| Frequency response: | 20 Hz - 20 kHz |
| Dynamic range: | Typ. 114 dB |
| Effective frequency range ±2 dB: | 50 Hz - 20 kHz with typ. 3 dB soft boost at 14 kHz |
| Sensitivity, nominal, ±2 dB at 1 kHz: | 40 mV/Pa; -28 dB re. 1 V/Pa |
| Equivalent noise level, A-weighted: | Typ. 16 dB(A) re. 20 µPa (max. 18 dB(A)) |
| Equivalent noise level, ITU-R BS.468-4: | Typ. 28 dB (max. 30 dB) |
| Distortion, THD < 1%: | 127 dB SPL RMS, 130 dB SPL peak |
| Max. SPL, THD 10%: | 146 dB SPL peak |
| Switchable attenuator, filters etc.: | 0 dB / -20 dB |
| Rated output impedance: | 200 Ω |
| Minimum load impedance: | 2 kΩ |
| Cable drive capability: | 100 m (328 ft) |
| Output balance principle: | Impedance balancing with Active Drive |
| Common mode rejection ratio (CMRR): | > 60 dB |
| Power supply (for full performance): | P48 (Phantom Power) |
| Current consumption: | 2.8 mA |
| Maximum output voltage, RMS: | 8 V |
| Polarity: | +V at pin 2 for positive sound pressure |
| Sensitivity selection tolerance (at 1 kHz): | ±1.5 dB |
| Microphone diameter: | 19 mm (0.75 in) |
| Microphone length: | 164 mm (6.5 in) |
| Temperature range: | -40°C to 45°C (-40°F to 113°F) |
| Relative humidity (RH): | Up to 90% |